pentair screenlogic will not connect to wifi

The transceivers provides a wireless connection between the ScreenLogic Interface Protocol adapter and the IntelliTouch® or EasyTouch® Control System Load Center located at the equipment pad. For more information, call Customer Support (880) 831.7133. Transceivers are replaced as a matched pair. The ID numbers on each transceiver must be the same number to function correctly. Note: The transceivers ship from the factory as a matched pair. The ScreenLogic® Interface Wireless Connection interface consists of an indoor and outdoor wireless 2.4 GHz transceiver.

For ScreenLogic Interface system operating instructions, refer to the ScreenLogic Interface User’s Guide (P/N 520493) ScreenLogic® Interface Wireless Connection Kit.

Use the information in this manual for installing the ScreenLogic® Interface Wireless Connection kit contents. Modifications not expressly approved by the party responsible for FCC compliance could void the user’s authority to operate the equipment.Consult the dealer or an experienced radio/TV technician for help.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Increase the separation between the equipment and receiver.

Reorient or relocate the receiving antenna.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Related manual: ScreenLogic® Interface User’s Guide (P/N 520493)įCC Regulatory Safety Notice – This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

Pentair screenlogic will not connect to wifi